Simplify3D User Forum

CCVirginia

This is a specific feature request as a follow-on to topic: https://forum.simplify3d.com/viewtopic.php?f=9&t=3357 Simplify provides controls for various surfaces, such as top/bottom, infill, etc. However, there is insufficient and inconsistent control for all surface kinds. The request is to ide...

CCVirginia

I suspect this is an "infill" issue, not a support issue for 2 reasons: 1) The much better print used the same support but changed the outline shell layers to eliminate infill. While there are a few rough spots (as would be expected), this print has a "tight" bottom. 2) There are...

CCVirginia

+1

Also, consider settings for "suspended bottoms" as are found over a support or as a bridge. Settings could include angle, pattern, speed and extrusion.

CCVirginia

On several models that have horizontal or near horizontal overhang I am getting an odd pattern of single threads, even with support (See picture - center of Guantlet). The horizontal area over the overhang is VERY rough. It seems like the way S3D handles this situation is not the best. I have tried ...

CCVirginia

It is often necessary to try a lot of settings for various filaments and prints and it can be a lot to keep track of. Simplify knows most of the information so it would be great if it could keep a print log so we could go back to each one and also print "like this". Each log entry could al...

CCVirginia

In addition to this, when starting a new print in this condition the Extruder temp is not set so the print never starts. It is necessary to set the extruder temp and then start the print, this should not be required.

Search found 6 matches

Explicit control of multiple surface types

Re: Horizontal-supported surfaces.

Re: Top Layer Angle

Horizontal-supported surfaces.

Print log

Re: 3.0 Extruder Temperature resets to 0 Degrees after paus