Simplify3D User Forum

mpd352

Just installed version 5.

Simplify3d v5 shows the model centered on the build surface:

Once imported to Octoprint it is offset to the lower right corner. Settings were imported from v4 and worked.

mpd352

Over time my starting and ending scripts for my Bibo 2 have gotten scrambled. Can I get a copy of them that are known to work?

Thanks.

mpd352

The parts printed OK on my A10T. Only mistake was failing to change the extruder for the brim to the left side spool, which was black ABS. It was set to the right, which was red PLA. Never the less, they printed. New Parts.jpg The new parts are on the bottom, and the broken original right hand piece...

mpd352

The simple 40mm x 40mm x 2mm rectangle printed OK. Some corner curling.

I'll try next with the brim airscapes recommended.

mpd352

As a test, I let the job run to completion. But, unfortunately, what I found was an issue with the raft and only the raft. The first layer of the raft laid down correctly. However, the second and subsequent layers of the raft are a mess. I suspect that the second and third layers of the raft are ext...

mpd352

Thanks for your reply. I do have an enclosure. I'll have to dig it out and try it.

Thanks!

mpd352

I’m trying to print ABS with my A10T. I need something a little more durable than PLA. I’ve read and re-read the tips and tricks for printing ABS, and am hitting a wall. I’ve set the file to print with a raft, cooling fans off, print temp at 222C and bed temp at 100C to start, then dropping to 85C. ...

mpd352

Is anyone using a GeeeTech A20T multi-color printer, and if you are do you have a working profile for it?

Thanks,

Kevin

mpd352

I have a GeeeTech A10T printer. I’m trying to implement a purge bucket to improve my multicolor prints. I’m not very familiar with G code, and the more I read the more confused I get. I have managed to move the axis over to where the purge bucket will be through direct input to the machine, so I kno...

mpd352

I have a GeeeTech A10T. When I move the X axis to the left, using the printer control panel, it hits 0 mm a full 20 mm inside the left edge of the build plate. To the right, 220 mm is about 5 mm inside the right edge. I want to install a purge bucket for multicolor printing, so at least to the left ...

Search found 16 matches

Version 5 moves origin

Bibo 2 Touch FFF Profile and Scripts

Re: GeeeTech A10T and ABS

Re: GeeeTech A10T and ABS

Re: GeeeTech A10T and ABS

Re: GeeeTech A10T and ABS

GeeeTech A10T and ABS

GeeeTech A20T Profile

Gcode for A10T Purge Bucket

Change the X-Axis limits in firmware A10T