Thanks for the pro tip!
Search found 5 matches
- Sat Aug 15, 2015 11:25 am
- Forum: Troubleshooting and Bug Reports
- Topic: FF Creator Pro - Right Extruder
- Replies: 4
- Views: 2510
- Jump to post
Re: FF Creator Pro - Right Extruder
Joe...you are my 3D printing guru. It's official.
Thanks for the pro tip!
Thanks for the pro tip!
- Fri Aug 14, 2015 7:52 am
- Forum: Troubleshooting and Bug Reports
- Topic: FF Creator Pro - Pre Heating platform & extruder
- Replies: 4
- Views: 2435
- Jump to post
Re: FF Creator Pro - Pre Heating platform & extruder
Thanks Joe! Sorry I couldn't find that post in my searches. That is exactly what I was looking for.
- Thu Aug 13, 2015 9:41 am
- Forum: Troubleshooting and Bug Reports
- Topic: FF Creator Pro - Right Extruder
- Replies: 4
- Views: 2510
- Jump to post
Re: FF Creator Pro - Right Extruder
After a couple of more tweaks, I got it to work by adding a raft. I printed this: http://www.thingiverse.com/thing:776532
I followed the instructions of printing him upside down. I then made him larger, but his shoulders were a mess.
I followed the instructions of printing him upside down. I then made him larger, but his shoulders were a mess.
- Wed Aug 12, 2015 4:32 pm
- Forum: Troubleshooting and Bug Reports
- Topic: FF Creator Pro - Pre Heating platform & extruder
- Replies: 4
- Views: 2435
- Jump to post
FF Creator Pro - Pre Heating platform & extruder
Is it possible to preheat the platform and extruder at the same time with the FlashForge Creator Pro? I know Replicator G does this, but I can't figure out where to set this in Simplify3D.
Thanks!
Thanks!
- Wed Aug 12, 2015 4:29 pm
- Forum: Troubleshooting and Bug Reports
- Topic: FF Creator Pro - Right Extruder
- Replies: 4
- Views: 2510
- Jump to post
FF Creator Pro - Right Extruder
Hi, Newbie here. I just got my FF Creator Pro last week and have successfully made several prints with my left extruder using Simplify3D. When I tried to do one on my right extruder, after it drops some filament off the platform and some on it, it then goes to make the model, but nothing is sticking...
