Search found 2 matches
- Thu Aug 20, 2015 8:42 am
- Forum: General Discussion and Tips
- Topic: Top Layer Angle
- Replies: 4
- Views: 3526
- Jump to post
Re: Top Layer Angle
Seems like top and/or bottom layers should have the ability to change the print angle.. Rotating the part to match the layer is not a solution, this works the Servos at 45 deg angles and gives step motions that can distort the print Straight lines are shorter and less print time... IF the developers...
- Wed Aug 19, 2015 4:06 pm
- Forum: General Discussion and Tips
- Topic: Top Layer Angle
- Replies: 4
- Views: 3526
- Jump to post
Top Layer Angle
New to Simplify3D
is there a way to change the 'angle' of the top layer from the default 45 ?
is there a way to change the 'angle' of the top layer from the default 45 ?
