Search found 6 matches
- Mon Nov 09, 2015 3:42 pm
- Forum: General Discussion and Tips
- Topic: Support issues
- Replies: 1
- Views: 1579
- Jump to post
Support issues
Hi Everyone, Im having issues with this one file and was wondering if it has happen to anyone else. So, on this one particular file simplify will not add support in the center part, It includes it on the outer edges, but excludes the center where it's concave. I have opened other parts, into the sam...
- Mon Aug 31, 2015 8:04 am
- Forum: General Discussion and Tips
- Topic: Multiple Passes
- Replies: 8
- Views: 4856
- Jump to post
Re: Multiple Passes
Hi Everyone, it was a frustrating week to say the least, but I finally have the solution. One of the Motor Drivers was bad and which cause the Y Motor and overheated about 20 minutes into the print, i was told to switch the X Driver and the Y Driver in the control box and sure enough started to prin...
- Fri Aug 28, 2015 9:10 am
- Forum: General Discussion and Tips
- Topic: Multiple Passes
- Replies: 8
- Views: 4856
- Jump to post
Re: Multiple Passes
JoeJ thanks I did re-position the Bed to the proper place before I got a little breeding, but quickly compensated for that after the print. Okay what i did here was to try and print a different part, but still got the same layer building issue. :? , however i did notice that the software is getting ...
- Wed Aug 26, 2015 4:16 pm
- Forum: General Discussion and Tips
- Topic: Multiple Passes
- Replies: 8
- Views: 4856
- Jump to post
Re: Multiple Passes
Yes, It did it with a much smaller print 2in x 10in. Running it from SD CardKeyboardWarrior wrote:Lord~Dragon wrote: Does this occur for smaller prints as well?
- Wed Aug 26, 2015 12:54 pm
- Forum: General Discussion and Tips
- Topic: Multiple Passes
- Replies: 8
- Views: 4856
- Jump to post
Re: Multiple Passes
JoeJ thanks for taking the time. I've checked the bed it's all good there, and the nozzle is right on. Here is the factory file Print Name One.factory . This a machine just out of the box so this is the first attempt at a print. I've also attempted to print something much smaller, but it did it all ...
- Tue Aug 25, 2015 4:52 pm
- Forum: General Discussion and Tips
- Topic: Multiple Passes
- Replies: 8
- Views: 4856
- Jump to post
Multiple Passes
Hi Everyone not sure where to post this or if anyone has posted anything like this. I've took some time to research and look, but I'm so new to the field of 3D Printing I don't even know what this is called. So here is a picture Misprint(sm).jpg . I'm using the GigabotXL with Simplify 3D. First I've...
