Simplify3D User Forum

luisdmanson

came here to ask for the same, i like Repetier's implementation, you can toggle the gcode view, from which i change some stuff from time to time, you can also click on a layer number and jump to the corresponding code

luisdmanson

Ok, well I'm not sure your firmware is setup correctly based on your answers. If (0,0,0) is in the back right, then you would expect that +X would move to the left, and +Y would move towards the front. But you said that +Y is actually going to the back, not the front. So something seems incorrect t...

luisdmanson

Ok, well if you can answer all of the questions, then I can help. Only guessing if you only answer 2 of 5 quesitons Sorry, i must have missed all of them because of the language barrier You probably just need to adjust your axis directions and zero position in the software. It's pretty easy. First,...

luisdmanson

You probably just need to adjust your axis directions and zero position in the software. It's pretty easy. First, open the machine control panel and click Home All. Where does the toolhead go to (i.e. front left) Then, click on the Communication tab and send the command "G1 X0 Y0 Z0 F3000"...

luisdmanson

Hello, i have an i3 rework, i want to make Simplify to display the bed as i have it in my machine, that is ( min endstops) , X to the right and Y (bed) near the front of the machine, Rightnow Simplify always start with its 0 at front left. http://i58.tinypic.com/2r77wj4.jpg Also, the jog controls ar...

Search found 5 matches

Re: G-Code Editor & Pause Command

Re: display coordinates as in the phisical machine

Re: display coordinates as in the phisical machine

Re: display coordinates as in the phisical machine

display coordinates as in the phisical machine