Thanks, I've actually already read it and attempted most of the solutions in it. I haven't had any issues with makerware which is why I assumed it was a S3D issue. *shrug* I'll keep tinkering with it, but it's costing me a lot of time and filament. Heh.
Thanks for the suggestions.
Search found 3 matches
- Fri Nov 13, 2015 7:04 am
- Forum: Troubleshooting and Bug Reports
- Topic: Solid layers on top of infill are all messed up
- Replies: 17
- Views: 12529
- Jump to post
- Thu Nov 12, 2015 5:42 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Solid layers on top of infill are all messed up
- Replies: 17
- Views: 12529
- Jump to post
Re: Solid layers on top of infill are all messed up
Increasing the layers doesn't seem to have any effect. Only recourse I've seen is to bump the infill but I can't see wasting all that plastic and increasing the print times by double or triple for a part (in this case it fits into a car cup holder) that doesn't need to be super strong. There's no ot...
- Wed Nov 11, 2015 9:02 am
- Forum: Troubleshooting and Bug Reports
- Topic: Solid layers on top of infill are all messed up
- Replies: 17
- Views: 12529
- Jump to post
Solid layers on top of infill are all messed up
I've been looking around and I see others with similar issues, but I'm not sure they're the same. Whenever I have infill that's lower than about 40% (which is usually) the gaps between the infill seem to be too wide for for anything solid to print over them. I've tried every type of infill, honeycom...
