Joe,
Also if you look on the simplify screen on the left side of product inside there are some lines inside the wall where should be a vase. This is not on project. Simplify added? If yes how I remove? Thanks.
Search found 3 matches
- Fri Sep 18, 2015 10:31 am
- Forum: General Discussion and Tips
- Topic: Printing problem on Flash Forge Creator pro
- Replies: 4
- Views: 1416
- Jump to post
- Fri Sep 18, 2015 8:29 am
- Forum: General Discussion and Tips
- Topic: Printing problem on Flash Forge Creator pro
- Replies: 4
- Views: 1416
- Jump to post
Re: Printing problem on Flash Forge Creator pro
I'm using a raft but after the raft I got 4 successful layers and then the wall problem. Can this be caused by the raft?
- Thu Sep 17, 2015 8:29 am
- Forum: General Discussion and Tips
- Topic: Printing problem on Flash Forge Creator pro
- Replies: 4
- Views: 1416
- Jump to post
Printing problem on Flash Forge Creator pro
Hi to all, Recently I started having a problem on my printing. The final product should be something like a vase but the wall doesn't attached to the lower section and sticks to extruder. What can be causing this? My printing pad is not in good quality. Can this be the reason? I tried to level the p...
