Search found 4 matches
- Sat Jan 02, 2016 10:00 pm
- Forum: General Discussion and Tips
- Topic: How can I make my PLA look better?
- Replies: 4
- Views: 1929
- Jump to post
Re: How can I make my PLA look better?
I did what you suggested and still have issues, I ended up removing the complete FFF file and installed it again with better results but still have issues.
- Thu Dec 17, 2015 8:41 pm
- Forum: General Discussion and Tips
- Topic: How can I make my PLA look better?
- Replies: 4
- Views: 1929
- Jump to post
Re: How can I make my PLA look better?
Thank you, I'll give it a shot right now. I changed the value to -0.1 and increased the outer speed from 70% to 80%.
- Wed Dec 16, 2015 7:17 pm
- Forum: General Discussion and Tips
- Topic: How can I make my PLA look better?
- Replies: 4
- Views: 1929
- Jump to post
How can I make my PLA look better?
So I have been printing with ABS for a while now and just started with PLA and my prints turn out like this.. I did some online search and found what I need to change but don't fully understand it so that's why I'm reaching out on here for help. Current settings: Settings.jpg 2mm Print: 4mm print.jp...
- Sat Oct 10, 2015 12:20 am
- Forum: General Discussion and Tips
- Topic: Why do my first layers turn out like this?
- Replies: 3
- Views: 2615
- Jump to post
Why do my first layers turn out like this?
I just started using Simplify 3D and my first layers are messy and end up making the bottom of my prints look bad. Below is a picture of two failed prints, you can see the extruder is either putting out too much on the first layer or I have some other setting wrong. If I continue the print it will j...
