Disregard.
I ran the mesh through netfabb and found issues
Fixed and printing fine.
Search found 4 matches
- Wed Oct 07, 2015 3:00 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Another Slicing error Missing Layer thread
- Replies: 1
- Views: 1188
- Jump to post
- Tue Oct 06, 2015 11:43 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Another Slicing error Missing Layer thread
- Replies: 1
- Views: 1188
- Jump to post
Another Slicing error Missing Layer thread
Okay, I have looked at some of the other slicing error threads and I am pretty sure I am running into something unique. I am printing out a pretty well known model, the buddha from thingiverse, but I am using the HD version http://www.thingiverse.com/thing:329057 Its 70 mb otherwise I would attach i...
- Tue Oct 06, 2015 12:50 pm
- Forum: General Discussion and Tips
- Topic: origin offsets and the build grid in S3D
- Replies: 2
- Views: 4085
- Jump to post
Re: origin offsets and the build grid in S3D
That is a possibility. Using the home controls in the machine control panel, when I tell it to home all axes it heads to the corner as I would expect. I will run through the test when I get home, maybe I will hook up octoprint to control the printer too. My printer had been offline since about April...
- Mon Oct 05, 2015 4:43 pm
- Forum: General Discussion and Tips
- Topic: origin offsets and the build grid in S3D
- Replies: 2
- Views: 4085
- Jump to post
origin offsets and the build grid in S3D
Recently upgraded to version 3 and found that my build grid did not align correctly to the realworld (ie prints were not printed in the same place on my build platform as they were shown in simplify 3D) For example a part printed in the center of the grid was actually shifted 20 mm towards the rear ...
