Search found 2 matches
- Fri Nov 27, 2015 11:04 am
- Forum: General Discussion and Tips
- Topic: Overhang treated like bottom solid layer
- Replies: 2
- Views: 1297
- Jump to post
Re: Overhang treated like bottom solid layer
Thanks a lot! I think i have to use two different processes. I tried this but at the end height of Process 1 (Stop printing at height) it always prints a solid diaphragm. Is there a way to deactivate this without deactivating Top (Process 1) and Bottom (Process 2) solid layers? (I have several steps...
- Fri Nov 20, 2015 12:09 pm
- Forum: General Discussion and Tips
- Topic: Overhang treated like bottom solid layer
- Replies: 2
- Views: 1297
- Jump to post
Overhang treated like bottom solid layer
Hi, i'm new with Simplify3D and i tried to print a part with an overhang. If you look at the picture you can see that the overhang was printed with bottom solid layers. I want it only to print with one outline. If i deactivate bottom solid layers the green parts are gone - but also i don't have a bo...
