Search found 7 matches
- Tue May 16, 2017 7:21 am
- Forum: General Discussion and Tips
- Topic: Autospace between objects
- Replies: 5
- Views: 7761
- Jump to post
Re: Autospace between objects
Nice idea. Hope this features will be implemented.
- Tue May 16, 2017 4:46 am
- Forum: General Discussion and Tips
- Topic: Autospace between objects
- Replies: 5
- Views: 7761
- Jump to post
Autospace between objects
Hi.
Is there any settings to tell the max/min space between objects when pressing the Center and Arrange-button? I want to tighten them to reduce print time, oozing and even put more objects on the bed.
Is there any settings to tell the max/min space between objects when pressing the Center and Arrange-button? I want to tighten them to reduce print time, oozing and even put more objects on the bed.
- Tue Feb 02, 2016 8:43 am
- Forum: Feature Requests
- Topic: Used filament counter.
- Replies: 2
- Views: 1745
- Jump to post
Re: Used filament counter.
Yes! Thanks 
- Fri Jan 29, 2016 10:18 am
- Forum: Feature Requests
- Topic: Used filament counter.
- Replies: 2
- Views: 1745
- Jump to post
Used filament counter.
Hi.
It would be a good feature to have the opportunity to record how much filaments are left on the current coil. Perhaps a small database which allows users to store data on multiple coils, if you switch to another.
Regards
Mikael
It would be a good feature to have the opportunity to record how much filaments are left on the current coil. Perhaps a small database which allows users to store data on multiple coils, if you switch to another.
Regards
Mikael
- Wed Dec 09, 2015 5:59 am
- Forum: General Discussion and Tips
- Topic: Where are profiles stored?
- Replies: 15
- Views: 52228
- Jump to post
Re: Where are profiles stored?
How to export profiles to an another computer! From the "old" computer where you have your profiles: Open Regedit and rightclick on Computer\HKEY_CURRENT_USER\Software\Simplify3D and choose Export. Save the .reg-file and move the saved file to the computer you want to "install" t...
- Thu Nov 26, 2015 7:33 am
- Forum: Troubleshooting and Bug Reports
- Topic: Communication errors?
- Replies: 3
- Views: 3310
- Jump to post
Re: Communication errors?
You have to choose the correct port and baud rate. You also need to make sure you have the Creatbot drivers already installed. It won't connect if you don't do that. I don´t know why but after I inserted the SD-card the missmatch error dissapeared. But I have an another issue. I tested to print the...
- Wed Nov 25, 2015 9:17 am
- Forum: Troubleshooting and Bug Reports
- Topic: Communication errors?
- Replies: 3
- Views: 3310
- Jump to post
Communication errors?
Hi. Just bought a Creatbot DX dual and Simplify3d. When connecting I get this message: Attempting connection at \\.\COM4... Testing plaintext communication protocol... Testing binary communication protocol... Connected to machine! WARNING: CRC mismatch detected And it seems not to "Begin printi...
