Simplify3D User Forum

myx_2000

Prior to every print, my printer does what I can only describe as a booger prime. It heads to the lower right corner, squirts a blob of plastic then heads off on it's merry way. This is all well and good, but I have a glass plate that I want to mount and it will knock right into the retainer if the ...

myx_2000

CompoundCarl, Thank you. I knew before I got my printer that I was going to purchase S3D. So, even though it came with the machine, I did not install ReplicatorG. I would like to think that Simplify3D could add the acceleration page to their software. It would be nice to only need dwell in one piece...

myx_2000

Joe, I can see that you have a lot of posts, and can see you have been here for some time, so hear that I will not just cork off. I do my homework ahead of asking. That said... I did search. I didn't find an answer. I have been looking for some way to adjust my acceleration settings for the good par...

myx_2000

I love the "place surface on bed" option. It makes life so much easier. I am looking for something similar so I can constrain Z rotations as well for easier placement of objects. I have held command, shift, option and all the combinations of like I would in say, Photoshop, but can't seem t...

myx_2000

Hey all, This is my first post here. I just got my printer about a week and a half ago. Before posting, I decided to get my hands dirty and walk through this several times first. I have watched the videos, and most of this makes sense. So... Having now tried many prints, the one thing I keep running...

Search found 5 matches

Where does Simplify3D begin and the firmware end?

Re: Printing time significantly different than build statist

Re: Printing time significantly different than build statist

Constrain Z-axis rotations

Printing time significantly different than build statistics