Search found 4 matches
- Wed Dec 16, 2015 2:49 am
- Forum: General Discussion and Tips
- Topic: Sliding print
- Replies: 4
- Views: 1831
- Jump to post
Re: Sliding print
What printer are you using? A Mendel Max 1.5 operating on Sprinter firmware. I built this printer almost 2 years ago and it's been flawless for hundreds of prints, most likely over 50 lbs of filament. In light of the post above, I'm going to unhook and unwrap the wiring harness of my MM1.5 and repl...
- Mon Dec 14, 2015 7:06 pm
- Forum: General Discussion and Tips
- Topic: Sliding print
- Replies: 4
- Views: 1831
- Jump to post
Sliding print
Hi Folks, I'm getting familiar with the interface and overall, very happy with how the work flow is with S3d. That's the good news, but I'm also having a problem that's totally mystifying to me. I can print a 20mm cube that's as perfect as you'd want and I've created a 1x4" cylinder that prints...
- Fri Dec 11, 2015 7:05 am
- Forum: General Discussion and Tips
- Topic: Pre purchase questions....
- Replies: 3
- Views: 2117
- Jump to post
Re: Pre purchase questions....
Yes, you can control multiple printers at once on the same computer. You just open multiple instances of the software and then you can position the control windows wherever you want so that you can see everything easily. I do it all the time. If you want to connect to computers via ethernet, I woul...
- Fri Dec 11, 2015 5:01 am
- Forum: General Discussion and Tips
- Topic: Pre purchase questions....
- Replies: 3
- Views: 2117
- Jump to post
Pre purchase questions....
Hello, I've not yet purchased the software because I cannot find the answer to a couple questions. Perhaps it's on the website and I'm looking in all the wrong places, so please pardon me if my first post here I need to ask for a bit of help. First of all can Simplfy3d address multiple 3d printers f...
