I just noticed that V 5.02 has print time "Remaining:" below the progress bar in the Machine Control Panel!
Thanks for that info!!!
Search found 4 matches
- Fri Mar 10, 2023 6:17 pm
- Forum: General Discussion and Tips
- Topic: Print time remaining
- Replies: 7
- Views: 3361
- Jump to post
- Tue Dec 27, 2022 5:42 pm
- Forum: General Discussion and Tips
- Topic: Print time remaining
- Replies: 7
- Views: 3361
- Jump to post
Print time remaining
Version 5. This is probably right in front of my eyes, but, where do I locate the amount of print time left while the object is printing? I see the Progress Bar on the Machine Control Panel. I'm looking for the estimated time left in hours and minutes. Thanks!
- Thu Jun 23, 2016 3:13 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Windows 10 USB Connection Question
- Replies: 35
- Views: 38344
- Jump to post
Re: Windows 10 USB Connection Question
About a month ago I elected to go to a wireless printing setup because of this issue. I don't know if there is a fix for it yet or not. I did not want to lose the power of S3D (I'm hooked on it). The solution I implemented uses a Raspberry Pi 3 following the directions in the link below. For about $...
- Sun May 08, 2016 10:34 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Windows 10 USB Connection Question
- Replies: 35
- Views: 38344
- Jump to post
Re: Windows 10 USB Connection Question
It seems to me that my experience printing thru MatterControl always works on Windows 10. And, S3D almost always randomly stops. The S3d communication window displays "Firmware unresponsive Attempting to force continue". Sometimes clicking pause/resume works. Other times you have to wait f...
