Search found 4 matches
- Mon Jan 04, 2016 5:49 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Extrude, X & Y stopped working
- Replies: 3
- Views: 1223
- Jump to post
Re: Extrude, X & Y stopped working
And now its not working again.
- Mon Jan 04, 2016 2:05 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Extrude, X & Y stopped working
- Replies: 3
- Views: 1223
- Jump to post
Re: Extrude, X & Y stopped working
After setting overnight, it is working again. Thanks, Carl. Are you the same Carl on the Soliforum?
- Sun Jan 03, 2016 9:53 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Extrude, X & Y stopped working
- Replies: 3
- Views: 1223
- Jump to post
Extrude, X & Y stopped working
Solidoodle 3 printer. I just started using the Bed Leveling Wizard. The filament got caught under the printer cover and kept the print head from going quite to the farthest point. It made the grunting noise and I immediately shot off the printer. Now, in the Control Panel, I am Jogging the extruder ...
- Thu Dec 31, 2015 4:43 pm
- Forum: General Discussion and Tips
- Topic: Any Solidoodle 2 or 3 users with E3D Lite here?
- Replies: 0
- Views: 858
- Jump to post
Any Solidoodle 2 or 3 users with E3D Lite here?
I am new to Simplify3D. I have an SD3 with E3D Lite hot end and the Hobgoblin drive gear. I'm wondering is anyone with the same setup would be willing to share their settings so I don't have to spend more time than necessary reinventing this particular wheel.
Thanks.
Kent in KC
Thanks.
Kent in KC
