Search found 5 matches
- Mon Oct 24, 2016 10:24 am
- Forum: Troubleshooting and Bug Reports
- Topic: Simplify3D Won't Launch Properly
- Replies: 26
- Views: 24097
- Jump to post
Re: Simplify3D Won't Launch Properly
I have been experiencing this exact same problem. just the other day, with my windows 10 surface pro, I would launch the software. I would get the error stating i have exceeded the amount of installs. that is false, because it is only on my surface pro and on my pc at work. the only way to get aroun...
- Mon Jan 11, 2016 4:13 pm
- Forum: General Discussion and Tips
- Topic: Machine Options and saving the orientation orientation
- Replies: 1
- Views: 1209
- Jump to post
Machine Options and saving the orientation orientation
Hello, I have a Maker Farm 10" printer so I used the Configuration wizard to set it up. With my Printer, X and Y home are in the back and to the right. Simplify 3D always opens up with it front and to the left (as if I were watching the printer from behind). I found the check boxes on the Tools...
- Sun Jan 10, 2016 2:21 am
- Forum: Troubleshooting and Bug Reports
- Topic: Print stopped 75% and bed went full Y out.
- Replies: 3
- Views: 1851
- Jump to post
Re: Print stopped 75% and bed went full Y out.
It worked! Awesome, I saved some pla.
I took your advice.
I put the failed print on the bed, Used the control panel n simplify to show me the hight. I then printed the rest. Glued, and it is a perfect match.
I took your advice.
I put the failed print on the bed, Used the control panel n simplify to show me the hight. I then printed the rest. Glued, and it is a perfect match.
- Wed Jan 06, 2016 7:43 am
- Forum: Troubleshooting and Bug Reports
- Topic: Print stopped 75% and bed went full Y out.
- Replies: 3
- Views: 1851
- Jump to post
Re: Print stopped 75% and bed went full Y out.
Awesome. I did not think about printing the missing half. That's a great idea. Thank you.
- Tue Jan 05, 2016 1:42 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Print stopped 75% and bed went full Y out.
- Replies: 3
- Views: 1851
- Jump to post
Print stopped 75% and bed went full Y out.
Hello, I am printing a BB8 Dome panel. It was 75% done, then the bed went all forward and the machine stopped. I have two part question... Makerfarm 10" 1.75 extruder Simplify3d gcode printing at 1.5 layer with 5 perimeter. BB8 Dome from BB8 Builders. Printing from Flash card..no pc connected F...
