Search found 3 matches
- Tue Nov 01, 2016 11:49 am
- Forum: Feature Requests
- Topic: Flash Forge Creator Pro single extruder printing heating
- Replies: 1
- Views: 739
- Jump to post
Flash Forge Creator Pro single extruder printing heating
When printing with a single extruder, the build plate and extruder do not heat up at the same time. The extruder does not start until the build=plate in finished. Everything heats up at the same time with dual extruding however. Please fix this, it wastes a lot of time when printing.
- Tue Nov 01, 2016 11:45 am
- Forum: Troubleshooting and Bug Reports
- Topic: Dual Extrusion Bug?
- Replies: 1
- Views: 777
- Jump to post
Dual Extrusion Bug?
I am not sure if this is a bug or not, but here I go. So when ever I use the dual extrusion wizard, I set the base profile to my usual profile for my left extruder. This profile only accounts for that extruder, and not the right extruder. Under the dual extrusion group, the two different colors are ...
- Wed Jan 13, 2016 7:13 pm
- Forum: Troubleshooting and Bug Reports
- Topic: FlashForge Creator Pro Prints starting in close right corner
- Replies: 1
- Views: 1302
- Jump to post
FlashForge Creator Pro Prints starting in close right corner
For some reason my the software thinks that the center of the build platform is on the close right corner. Also the print % jumps immediately to 21% when the print starts. And finally and unfortunatelly the extruders dont start to heat up until the bed has reached the set temperature. Thanks for any...
