Simplify3D User Forum

rv_el

I am definitely interested in this. I'd like to get the version I used years ago that worked great. I think i've been unable to use Simplify3d since 4.0

rv_el

Attached image. It looks like the bed is uneven and/or needs to be releveled but with out touching it i'm printing the same object using Maker Desktop in the same way and that same base layer is far better. I've done a lot of printing so i am used to leveling. May be for Simlify3d i need to make it ...

rv_el

I would like to know how to restore defaults. The answer above doesn't seem like a good one because you can save to the profile. After that I have a Default and a Replicator 2. The Rep 2 should be modded because of my save. The default is naturally non descript. When i flash between the 2 i see chan...

rv_el

I used to love Simplify3d but at some point I had to go back to Maker Desktop. i recently had a Maker Desktop X3G fail on me a few times so i tried Simplify3d again. I'm all updated on firmwares and softwares here and i set up my Simplify3d and was quickly reminded why i left. While the base layer c...

rv_el

Perhaps not the best solution to your problem but here's a suggestion. Set the number of perimeters up to a point where small features are printed solid. For instance with a .5mm tip width and 5 perimeters you 100% fill a 2.5mm feature. This will increase the shell thickness over the whole part but...

rv_el

I bought Simplify3d and have been getting some good prints out of my Makerbot 2. So that is great. This is the first time I've cared about doing stuff with supports in a long time too. When I talked to my coworkers about 3d printing and Simplify3d came up one of the guys said "You can print wit...

Search found 6 matches

Re: Where can I download the older (functioning...) version?

Re: Rep 2 prints don't print well - first layer is bad

Re: Reset profile

Rep 2 prints don't print well - first layer is bad

Re: Variable Infill workflow.

Variable Infill workflow.