Search found 4 matches
- Sat Feb 20, 2016 5:35 pm
- Forum: General Discussion and Tips
- Topic: Autolevelling integration for Robo 3D R1
- Replies: 24
- Views: 29686
- Jump to post
Re: Autolevelling integration for Robo 3D R1
I have, and the start script is there and it runs G29. Before starting the print it goes through the same multi point leveling. It is after that it just seems like it was only going through the motions of auto leveling but not applying any adjustments. Any print larger than a few cm in the middle of...
- Sat Feb 20, 2016 10:55 am
- Forum: Troubleshooting and Bug Reports
- Topic: Robo3D R1+ - Under extrusion issue?
- Replies: 5
- Views: 7561
- Jump to post
Re: Robo3D R1+ - Under extrusion issue?
Thank you. I'm trying to be sure the bed is level now. Doesn't seem to be a whole lot of adjustments on this printer.
- Fri Feb 19, 2016 4:21 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Robo3D R1+ - Under extrusion issue?
- Replies: 5
- Views: 7561
- Jump to post
Robo3D R1+ - Under extrusion issue?
Following the print troubleshooting guide and comparing it to my issue I thought it looked like under-extrusion, so I bumped up the extrusion multiplier to 1.0 from .9 (printing PLA. using the stock medium profile for the standard auto-leveling fff. Any help is greatly appreciated, I'm just starting...
- Tue Feb 16, 2016 3:08 pm
- Forum: General Discussion and Tips
- Topic: Autolevelling integration for Robo 3D R1
- Replies: 24
- Views: 29686
- Jump to post
Re: Autolevelling integration for Robo 3D R1
I hate to dig this up, but it's a big part of my registering and joining the community is this problem. I'm running a R1 Plus and am wondering about this macro, I didn't think it through before purchasing that MatterControl is in charge of the autolevel that I sorely miss with Simplify3d. Any help? ...
