Search found 5 matches
- Sat Feb 27, 2016 6:30 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Extruder only heating up after the platform?
- Replies: 1
- Views: 1990
- Jump to post
Extruder only heating up after the platform?
I am using a Flashforge Creator Pro. I've had it for about a month now, and every time I've gone to print something it will heat up the build platform and the extruder at the same time. However, a few hours ago it started only heating up the extrude AFTER the build platform was fully heated. This do...
- Tue Feb 23, 2016 7:41 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Help with supports
- Replies: 1
- Views: 1015
- Jump to post
Help with supports
It seems that when I'm printing, the program will put the supports on MOST overhangs, but not all of them. Sometimes it will not put supports on overhangs that are worse than others, but then put it on overhangs that aren't as bad.
- Fri Feb 19, 2016 6:54 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Moving a part on the build plate
- Replies: 5
- Views: 1904
- Jump to post
Re: Moving a part on the build plate
Sorry, I'm not sure what you mean by firmware... I'm new to 3d printingCompoundCarl wrote:What firmware did you install on it? You need to change the homing offsets in your firmware
- Thu Feb 18, 2016 6:58 am
- Forum: Troubleshooting and Bug Reports
- Topic: Moving a part on the build plate
- Replies: 5
- Views: 1904
- Jump to post
Re: Moving a part on the build plate
Flashforge Creator ProCompoundCarl wrote:That probably means your homing offsets are incorrect in the firmware. What printer do you have?
- Tue Feb 16, 2016 8:00 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Moving a part on the build plate
- Replies: 5
- Views: 1904
- Jump to post
Moving a part on the build plate
So I've moved a part farther to the left than it would normally be. However when I go to print it, the model is printed in the center as if I had never made the change.
