Search found 3 matches
- Tue Mar 15, 2016 4:21 am
- Forum: Troubleshooting and Bug Reports
- Topic: Print is good, except for .5 mm too tall
- Replies: 5
- Views: 5830
- Jump to post
Re: Print is good, except for .5 mm too tall
After my last test print, there was a slight decrease in height, about .2 mm. I went ahead and changed the steps /mm as mroek sugessted, the test was much better. So, here is what I did to get my print within .1 mm height. Changed the steps / mm per mroek suggestion Set nozzle height at .2 mm above ...
- Mon Mar 14, 2016 3:38 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Print is good, except for .5 mm too tall
- Replies: 5
- Views: 5830
- Jump to post
Re: Print is good, except for .5 mm too tall
Hi, And thanks for the responses, layer height is .2 mm, Z axis steps per mm were something like 405.9000 blah blah, after my attempt at calibration I came up with 402. and some decimals. So, mroek, you say 400 is the correct value? I have yet another test print going right now. I verified Z level, ...
- Sun Mar 13, 2016 4:22 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Print is good, except for .5 mm too tall
- Replies: 5
- Views: 5830
- Jump to post
Print is good, except for .5 mm too tall
Hello Everyone, My name is Philip Hiatt, I am a fairly new user of S3D, and I always try to figure things out for myself unless I get stumped, which is why I am posting here. Duplicator i3 .4 mm nozzle Bed @ 85 C Extruder @ 260 C ABS The problem: My prints come out very good, length and width are sp...
