Search found 2 matches
- Wed Feb 24, 2016 9:26 pm
- Forum: General Discussion and Tips
- Topic: Autolevelling integration for Robo 3D R1
- Replies: 24
- Views: 29737
- Jump to post
Re: Autolevelling integration for Robo 3D R1
I found my problem!!! Using auto-bed leveling, I found the rear-left of the print was too high, and the front-right was pressed against the glass. For 3D printers which use *two* z-axis limit switches, these switches may trigger at different heights. So when the z offset is compensated for the dista...
- Tue Feb 23, 2016 9:49 pm
- Forum: General Discussion and Tips
- Topic: Autolevelling integration for Robo 3D R1
- Replies: 24
- Views: 29737
- Jump to post
Re: Autolevelling integration for Robo 3D R1
I'm having the same problem as Yogi. I wouldn't say that the auto-leveling *isn't* working, because as S3D is moving the head around the bed, the z rods are turning ever-so-slightly. Using MatterControl, it works perfectly across the whole bed. Using S3D, the back-left of the bed is too high and the...
