Search found 3 matches
- Thu Apr 21, 2016 9:46 am
- Forum: General Discussion and Tips
- Topic: New to the forum, Simplify3D is the best!
- Replies: 4
- Views: 1413
- Jump to post
Re: New to the forum, Simplify3D is the best!
Early tests with using the second extruder for infill haven't been that great. Fun experiment but ultimately not as great as I'd like. So I'll just stick with the one extruder and go from there. Thanks for the advice!
- Tue Apr 19, 2016 6:59 am
- Forum: General Discussion and Tips
- Topic: New to the forum, Simplify3D is the best!
- Replies: 4
- Views: 1413
- Jump to post
Re: New to the forum, Simplify3D is the best!
Yeah, I've been experimenting with dense supports. The first model had them, I had the dense support layers set to 12 with and infill of 70%. I'm not sure if that was enough considering the size of the model and the low layer height of .05mm. I use to have really bad issues with the supports making ...
- Mon Apr 18, 2016 1:04 pm
- Forum: General Discussion and Tips
- Topic: New to the forum, Simplify3D is the best!
- Replies: 4
- Views: 1413
- Jump to post
New to the forum, Simplify3D is the best!
Hello all! I'm new to the forum but I've been using Simplify3D for a while now. I was gifted a Monoprice Dual Extruder printer over a year ago, and only unboxed it and set it up a few months ago. Since then I've been tinkering and experimenting with getting detailed prints out of it, and have really...
