OK, after a bit of quality time with strace I found that I had a permissions error. $HOME/.local/share/Simplify3D was owned by root (so it seems that at some point I did start it up with sudo). I was having another problem with S3D not saving my settings between sessions, and it was also a permissio...

I moved from a Mac to Linux some months ago but hadn't opened Simplify3D yet. I opened Simplify3D (4.1.1) and imported my .fff profile previously exported from the Mac. I then imported a model, edited the process settings accordingly, and tried to slice ("Prepare to Print!"). I got a message in the ...

No prob, I might have overreacted a bit

I still have my Mac around so I guess I can deregister on Linux, register on the Mac, and export everything. Thanks for your help!

Pardon me Doug, but for practically ALL of the software I use, the answer is "copy files blablabla from $HOME/Library/SomethingOrOther to $HOME/.config/.somethingOrOther". So it's MY fault that the S3D configuration is so messed up that it's impossible to change from one UNIX-based OS to another? I'...

Hi, Until recently I used to use a Mac before moving to Linux. I deregistered the Mac installation of S3D and registered on my Linux box. From what I've been able to find out, on Linux S3D settings are stored in `$HOME/.config/Simplify3D. In the Mac, the settings are stored in `$HOME/Library/Applica...

There were some mistakes and I did some fine tuning. I've tested this using dual extrusion and it works. Note that Lulzbot's Marlin does not have the hotend offsets built-in, so you'll have to enter the following commands via whatever printer control software you use (I use OctoPrint's Terminal wind...

OK, I think I have one (not tested yet, though). Based on the Dualstruder v2 profile, changing the toolhead offsets and the names of the extruders, adding my own start/end gcode scripts, and some other changes. Again, this is untested, so YMMV.

Hi,

It's probably too soon, but... could we have a profile for the TAZ 5 with the Dual Extruder v3?

Thanks!

I'm wondering if this could be done in a similar way to how dual-extruder is done... 2 models, 2 different processes, only using the same toolhead.

Hi, I have several profiles now, basically for different types of filament. However, there are some settings (especially the scripts tab) that I would like to share between all of them, so that when I make a modification it will not have to be manually copied to every profile. Is there a way to do i...