Simplify3D User Forum

sonra

Hi guys
I finish to build the kit and try a very simple i got an profile file from S3D support for ver 5 and try to print
The print speed is VERY,VERY slow
does any one run S3Dc on MK4 i will be very glad to hear remarks. advice from him
Regards ahead Doron

sonra

Hi
I add also pic from connect using ver 4 the some pc and printer

sonra

Hi
Uninstall the ver 5 software
Install ver 4 and the printer connected with no problem
install again ver 5 try to connect and get the some message
try again ver 4 no problem
disabled Norton firewall but he some result
Any idea ?

sonra

Hi
I did add new and it connect the printer on the USB port preform the connection test but after this when I press the"connect "button in the Contro; Panel i get the message
Does the S3D open any log file that can help to see the problem ?

sonra

Hi, I use the licensed software ver 5.1 for some time . I had to replace the printer Prusa MK3 controller board because one of the motor driver stop working. After i replaced the board and run the printer setup I try to connect it to the S3D software .From the Machine Control Panel I connect to one ...

sonra

Hi guys I want to print a round rod that its radius is 1.5 mm .I design the rod using OpenScad software and try several "smooth" command with different numbers but when try to print the rod it printed like a square rod not nice circle . Is it possible to print this kind of rod and if yes a...

Search found 6 matches

Prusa MK4 speed issue

Re: stop working with Prusa MK3

Re: stop working with Prusa MK3

Re: stop working with Prusa MK3

stop working with Prusa MK3

print round rods