Search found 4 matches
- Wed Feb 03, 2021 9:13 pm
- Forum: Troubleshooting and Bug Reports
- Topic: "Failed to create final toolpaths"
- Replies: 8
- Views: 8667
- Jump to post
Re: "Failed to create final toolpaths"
Just found this. Thank you guys!
- Fri Mar 18, 2016 6:25 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Da Vinci 1.0 with repetier firmware not connecting
- Replies: 7
- Views: 6908
- Jump to post
Re: Da Vinci 1.0 with repetier firmware not connecting
Thanks everyone. In the end, I'm not sure what got it working; It could have been the restart (computer and printer), or going through and slightly changing some of the S3D settings. Either way, it is working now.
Thank you again for you help.
Thank you again for you help.
- Thu Mar 17, 2016 2:52 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Losing Communication to Davinci 1.0 with Repetier
- Replies: 12
- Views: 13224
- Jump to post
Re: Losing Communication to Davinci 1.0 with Repetier
My Da Vinci 1.0 flashed with Repetier .92 also now connects (thanks to this thread), but it in the communcation tab of the Machine Control Panel it says: Attempting connection at \\.\COM18... Connected to machine! SENT: T0 SENT: M105 SENT: M105 SENT: M105 SENT: M105 SENT: M105 and when I click on so...
- Thu Mar 17, 2016 12:34 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Da Vinci 1.0 with repetier firmware not connecting
- Replies: 7
- Views: 6908
- Jump to post
Da Vinci 1.0 with repetier firmware not connecting
Hi everyone, I am new to S3D, but am looking forward to using it. My issue is that I have a XYZ Da Vinci 1.0 that I flashed with repetier FW. S3D pre-configured for the Da Vinci when I installed it, but the printer will not connect to S3D. I have done the following: - verify the printer serial port ...
