Search found 3 matches
- Mon Apr 11, 2016 7:05 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Support Material - Rough Bottom Finish
- Replies: 11
- Views: 8411
- Jump to post
Re: Support Material - Rough Bottom Finish
I appreciate the feedback. Dense support structures helped but not significantly. And while I might ultimately end up at a "slice and glue" solution, I'm not ready to give up just yet. I was also thinking it might be thermal so I turned off the heated platform but, again, the improvement w...
- Fri Apr 08, 2016 11:30 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Support Material - Rough Bottom Finish
- Replies: 11
- Views: 8411
- Jump to post
Support Material - Rough Bottom Finish
Any suggestions as to what might be causing such a rough finish on the underside of an object printed with support material? As a test, I'm trying to print a 25.4mm sphere with auto-generated support material. Infill %: 30 Inflation: 0mm Dense support layers: 0 Dense infill %: 70 Print support every...
- Wed Mar 23, 2016 12:21 pm
- Forum: Troubleshooting and Bug Reports
- Topic: First print layers density question
- Replies: 36
- Views: 54996
- Jump to post
Re: First print layers density question
--snip-- ...found that if I set the 1st layer height to 300 percent, 1st layer width of 100 percent, and 1st layer speed set to 50 percent I got better adhesion and coverage. The difference was remarkable. Not sure about anyone else but for me, perimeters weren't ever a problem but these settings f...
