Search found 6 matches
- Wed Mar 06, 2024 2:33 pm
- Forum: General Discussion and Tips
- Topic: V4 License
- Replies: 9
- Views: 12723
- Jump to post
Re: V4 License
Ah, so you upgraded to v5? Yes, that's sadly a consequence when upgrading... if I remember correctly they See, that’s the confusing thing, I never DID buy the upgrade — that’s just the only option that’s showing up on my license. Looks like I’ll contact the team directly as suggested above. Thanks ...
- Wed Mar 06, 2024 2:30 pm
- Forum: General Discussion and Tips
- Topic: V4 License
- Replies: 9
- Views: 12723
- Jump to post
Re: V4 License
Purchasing V5 doesn't make any changes to your V4 license. You can keep using V4 exactly like you were previously. If you're having trouble using the V4 license, might be better to contact our team directly at the link below since they will be able to see much more information about your account: h...
- Sat Feb 24, 2024 3:34 pm
- Forum: General Discussion and Tips
- Topic: V4 License
- Replies: 9
- Views: 12723
- Jump to post
Re: V4 License
Works perfectly fine as before using v4, just tested this: v4lic.JPG Two installations/activations as before. You don't happen to have old activations inside your user profile/license management? Sorry, I was a bit upset yesterday, thank you for giving me the benefit of the doubt. Unfortunately, st...
- Fri Feb 23, 2024 6:51 pm
- Forum: General Discussion and Tips
- Topic: V4 License
- Replies: 9
- Views: 12723
- Jump to post
Re: V4 License
Not true in my experience! I’m in v4 and can’t activate a second time, just my original installation. This is unacceptable. I’ve only been using S3D for... EIGHT YEARS. I’m glad that getting a new printer prompted me to consider other slicers; this company has been a joke to Reddit users for a long ...
- Wed Mar 30, 2016 1:30 pm
- Forum: Troubleshooting and Bug Reports
- Topic: MG2 V4 rev D filament guide tube issue?
- Replies: 4
- Views: 2069
- Jump to post
Re: MG2 V4 rev D filament guide tube issue?
Fantastic, thanks for the replies everyone! ...and I've never had any issues that can be attributed to the end of the tube dancing up and down as filament retracts and feeds! I've even had it come adrift at the other end and the tube has floated around being held between the top of the print head a...
- Mon Mar 28, 2016 1:59 pm
- Forum: Troubleshooting and Bug Reports
- Topic: MG2 V4 rev D filament guide tube issue?
- Replies: 4
- Views: 2069
- Jump to post
MG2 V4 rev D filament guide tube issue?
Hi everyone -- Is the guide tube supposed to actually insert into the top of the extruder? Because as shown in the Simplify3D final hardware checks, it appears to do so https://www.simplify3d.com/wp-content/uploads/2014/03/mg-Extruder.jpg but maybe that's not the case and it's just resting there? Th...
