Search found 3 matches
- Sun May 15, 2016 11:44 am
- Forum: Feature Requests
- Topic: Feature for Selective Changing Suppport direction X to Y
- Replies: 1
- Views: 1427
- Jump to post
Feature for Selective Changing Suppport direction X to Y
A great feature would be to have the direction of the support material change from either the X direction to the Y direction. I am printing Speaker rounds with a 3/4" thin over hang on the outside. Where the support material goes perpendicular to the round edge the support is strong, where it g...
- Thu Apr 14, 2016 3:52 pm
- Forum: General Discussion and Tips
- Topic: Printrbot Play Heated bed
- Replies: 2
- Views: 1635
- Jump to post
Re: Printrbot Play Heated bed
Go to File > Export FFF Profile to save your profile to your hard drive, then open it in a text editor. If you scroll down to the bottom, you will see all of the <autoConfigureMaterial> sections. The tags inside those sections determine what settings are changed for different materials. So if you w...
- Thu Apr 14, 2016 1:39 am
- Forum: General Discussion and Tips
- Topic: Printrbot Play Heated bed
- Replies: 2
- Views: 1635
- Jump to post
Printrbot Play Heated bed
I have a Printrbot play with a heated bed and I have added the Headbed to the Temperature Control list. However when I add a Material Such as ABS and set up the the Temps for ABS, when I change between the Materials to say PLA, the extruder temps are correct, but the heatbed temp stays the same in b...
