Simplify3D User Forum

technobabble

For information, if you have this issue again you will need to add support manually.....which is quite easy to do. Try it now on this object so you get some practise....

I'll certainly look into it. Thanks Doug

technobabble

If the ridge is to the bottom when printing then I would say it needs some supports since it looks to be printing in air. Maybe the extrusion multiplier is a bit high also? When I added support (22% regular, 35% dense), it generated supports, but they didn't go as high as the ridge. I'm not sure if...

technobabble

Hello, I am trying to print out a lid for a part. I've been printing it like a bowl (see picture), however a consistent ridge along the outer part forms. It is about the same width around, which means that the part isn't shifting. Has anybody had this problem and solved it? Material: ABS, black Prin...

technobabble

Hello, I've been trying to print a part in ABS, with HIPS support and an ooze shield. Bed adhesion and the HIPS part of printing is fine, however when it starts to print the actual model in ABS, it tends to "rock" a little as the ABS extruder prints, gets stuck to the extruder, and falls o...

technobabble

Sounds like it should be fine. Thanks!

technobabble

Hey all, I'm tempted to purchase a Powerspec Ultra (Flashforge Dreamer Internals) from Microcenter, but the one thing that's stopping me are the compatibility issues with S3D that I read in other posts. As of today are the machines and softwares fully compatible, or do I still have to downgrade to t...

Search found 6 matches

Re: Part sags in on itself

Re: Part sags in on itself

Part sags in on itself

ABS not Sticking to HIPS Support

Re: PowerSpec Ultra / FF Dreamer Compatibility Status

PowerSpec Ultra / FF Dreamer Compatibility Status