Search found 4 matches
- Thu Sep 01, 2016 9:25 am
- Forum: General Discussion and Tips
- Topic: Top layer infill/outer shell glob issue.
- Replies: 2
- Views: 2198
- Jump to post
Re: Top layer infill/outer shell glob issue.
Just rotate the part, then the exterior infill angle will change relative to the part And for your question about over-extrusion, I would never try to make a decision on that based on the first layer alone. That is affected far too much by the first layer position. It would be better to print 20 or...
- Wed Aug 31, 2016 10:01 am
- Forum: General Discussion and Tips
- Topic: Top layer infill/outer shell glob issue.
- Replies: 2
- Views: 2198
- Jump to post
Top layer infill/outer shell glob issue.
I forgot to take a picture before heading to work. Just try to bare with me. The picture below is one I got off the internet, the build table is not close enough to the nozzle for the first layer, etc. What it does, is help explain my problem. When the print head goes to infill operation after doing...
- Sun Apr 24, 2016 11:02 pm
- Forum: General Discussion and Tips
- Topic: Can't get a succesfull print with Creator Pro and S3D
- Replies: 6
- Views: 4653
- Jump to post
Re: Can't get a succesfull print with Creator Pro and S3D
Yes I add the same amount as in flashprint who was successful.
Could you tell me how to make the supports more dense as you described? Thanks for the help!
Could you tell me how to make the supports more dense as you described? Thanks for the help!
- Sat Apr 23, 2016 9:21 pm
- Forum: General Discussion and Tips
- Topic: Can't get a succesfull print with Creator Pro and S3D
- Replies: 6
- Views: 4653
- Jump to post
Can't get a succesfull print with Creator Pro and S3D
Out of the gate I'll say I am new. However! I use flash print and printed it wonderfully. Learning curved on the supports (used the tree one by mistake). However I've tired literally all day to make this successful in S3D. So far I've *Change the Deafult Printing speed from 60mm/s to 30 *Primarily l...
