Search found 3 matches
- Wed May 18, 2016 6:56 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Supposedly "exceeding build dimensions"
- Replies: 7
- Views: 6684
- Jump to post
Re: Supposedly "exceeding build dimensions"
in your machine definition make sure your offsets are setup correctly. I am on a delta and didn't have them set correctly and it was telling me all the time that I was outside print area.
- Wed May 18, 2016 6:42 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Strange behavior of the printer
- Replies: 4
- Views: 2400
- Jump to post
Re: Strange behavior of the printer
I have had this happen to me if the room temperature changes in the middle of a print. In my office I have a window unit and if I turn it on or off during a print causing a change in temp in my office this will happen.
- Thu Apr 28, 2016 9:45 pm
- Forum: Feature Requests
- Topic: Send GCode Directly to OctoPrint
- Replies: 108
- Views: 225739
- Jump to post
Re: Send GCode Directly to OctoPrint
I went into the Pi running Octoprint and SMB shared the uploads folder. Then I mounted that fodler on my S3d machine now I can just save tool paths to disk and boom there they are n OctoPrint. Would be nice to be able to auto-magically start prints in Octo right from S3d!!!
