Simplify3D User Forum

georgei

I have test it in different pieces and I can add to the above that this is valid for supports that they are inside the piece.
You can remove the supports that they are from the floor to the piece but not supports that they are from the piece to the piece (like in a hole.

georgei

I have a piece that has holes for bolts. The automatic support generation put supports there. So I go to cross section view to see the internal supports (which I can) but when I click "Remove existing supports" and click on the supports nothing happens. Have in mind that I can remove suppo...

georgei

I have spent about 3 hours to set-up a complicated job with multiple parts and multiple processes. The I save the factory file so that I am able to make any changes later. When I have open the factory file surprise-surprise. All the processes are gone. What is the point to save a factory file if it ...

georgei

That is exactly what I wanted Owen.

Thank you very much.

George

georgei

Nobody hasn't got the value?

It is in Tools - Options - Visualisation

George

georgei

Does anyone know what is the default value for Vertex buffer size?

Thank you,

George

georgei

It happens with Windows 10 only. I just changed to another computer with Windows 7 and prints the all day without any problem at all.
The point is that in a years time you will not be able to find any new computer with windows 7 so this one has to be sort it out.

georgei

It happens with Windows 10 only. I just changed to another computer with Windows 7 and prints the all day without any problem at all.
The point is that in a years time you will not be able to find any new computer with windows 7 so this one has to be sort it out.

georgei

It will make sense if the supports where not dense.
But the last two layers of supports are 90% infill.
The bridge layer just make a total mess of the surface because it follows of course the bridge settings (which are not for printing over a solid layer).

georgei

Hi, I am printing some boxes that they have to print face down and therefore need supports. The strange is that s3d even though that calculates correct the supports on top of them is putting also a bridge (attached images). Isn't that a little crazy? What is the point of the supports then? Capture2....

Search found 30 matches

Re: Cannot remove internal supports when you have open the cross section view.

Cannot remove internal supports when you have open the cross section view.

Factory file doesn't save process

Re: Default value for Vertex buffer size

Re: Default value for Vertex buffer size

Default value for Vertex buffer size

Re: Random Stops during Print

Re: Freeze for few seconds middle of printing

Re: S3D puts bridge on top of supports

S3D puts bridge on top of supports