Simplify3D User Forum

JWest

I bought s3d for my creator pro 2015 and never regretted it. However, it does require a lot of tinkering to get the best out of it. It depends how much detail you want.

JWest

You can use nozzle lift but the question should also be why it is happening. Over extrusion can often cause scarring as the extruded plastic fans out in all directions making it thicker than the layer height expected by the slicer. This can be an accumalative effect.

JWest

I have just printed a miniature on a creator pro at 0.08mm layer on a 0.4mm nozzle. Not bad but the print time is huge.

JWest

This almost certainly going to be either an over extrusion or z height issue. More likely over extrusion, trying tweaking your extrusion multiplier. Have a read here: https://www.simplify3d.com/support/print-quality-troubleshooting/#scars-on-top-surface Unless the scar is going up your print on the ...

JWest

So you are getting a line across your model where the red line shows, is that the problem? This is probably caused by the print head moving through over extruded plastic often causing scaring. If you are saying the problem is blobs or zits on the outside walls this could be a retraction issue. Witho...

JWest

Thanks for your reply, I am using an FF Creator Pro with Sailfish7.7 and not too sure how to find the jerk setting? interestingly however, i changed the print underspeed from about 10mm/s to about 30mm/s and the print actually looks better at the higher speed using S3D v3.1.1, if i slow it down agai...

JWest

Hi Everyone, Please have a look at the attachment. I have upgraded to v4 and all of a sudden I am getting these lines on my prints. Before this printed smooth. These are happening it would seem as the extruder is over extruding on the outer perimeter at the start. The extruder is going left to right...

JWest

Ok, I was unaware of this, thanks for letting me know

JWest

Hi All, I am suffering some strange issue with the Machine Control Panel. I am using a FF Creator Pro 2015. If I select tool head 0 then everything works as expected. If i select tool head 1, things go weird when on manual control: X, Y, Z does not move in the selected size step, they move a large s...

JWest

Hi All, I seem to be suffering from a wobbly edge on all my square based prints, its only ever on the left hand corner of every straight and starts from about 5mm before the corner. I have tried my best to take a picture of it: DSC_0344_02.JPG Watching it print you can see it print the wobbly bit bu...

Search found 14 matches

Re: Simplify3D - Amazing with FlashForge Creator Pro!

Re: How To Avoid Extruder Travel over Internal Area Of Print

Re: FlashForge Guider II - help printing miniatures

Re: Printing With Polyalchemy Elixire problems

Re: Printing With Polyalchemy Elixire problems

Re: Beginning of outside perimeter issues

Beginning of outside perimeter issues

Re: Strange issues with FF Creator Pro toolhead jogging

[SOLVED] Strange issues with FF Creator Pro toolhead jogging

Wobbly Edge