Search found 3 matches
- Sat May 14, 2016 6:54 pm
- Forum: General Discussion and Tips
- Topic: Script or MCode for home X & Y axis at end of print job.
- Replies: 2
- Views: 12101
- Jump to post
Re: Script or MCode for home X & Y axis at end of print job.
Hey JD G28 is the gcode to home all axes. If you want to home a specific axis use the name of the axis after the code. eg. G28 X ;homes X axis G28 X Y ;homes X and Y If at any point you want a detailed definition of all Gcodes you can have a look here: http://reprap.org/wiki/G-code#G28:_Move_to_Orig...
- Fri May 13, 2016 5:54 pm
- Forum: General Discussion and Tips
- Topic: Unnecessary raft size?
- Replies: 2
- Views: 1304
- Jump to post
Re: Unnecessary raft size?
Thank you for the answer andrew,
I know the function of a brim its just that sometimes i would like to get the finish of a raft underneath.
I know the function of a brim its just that sometimes i would like to get the finish of a raft underneath.
- Thu May 12, 2016 12:49 pm
- Forum: General Discussion and Tips
- Topic: Unnecessary raft size?
- Replies: 2
- Views: 1304
- Jump to post
Unnecessary raft size?
Hello everyone, I am really new to S3D so please don yell if this is something obvious. I am trying to print the following part and I can se the unnecessary big raft. Cura slices the same file with a patch on the base and a patch on the support. The unused raft is calculated to about 15g of unused m...
