Search found 3 matches
- Thu Nov 10, 2016 1:36 am
- Forum: Troubleshooting and Bug Reports
- Topic: Hot end won't reach set point
- Replies: 5
- Views: 2015
- Jump to post
Re: Hot end won't reach set point
I do have a cooling fan but it's not coming on. The small fan connected to the extruder stepper motor comes on but that shouldn't affect the hot end should it? What stumps me is the fact that everything works fine from the printer control panel but not from Simplify3d.
- Wed Nov 09, 2016 12:15 am
- Forum: Troubleshooting and Bug Reports
- Topic: Hot end won't reach set point
- Replies: 5
- Views: 2015
- Jump to post
Hot end won't reach set point
This started right after update. Using single nozzle with set point at 200c, I have a hot bed but it's not being used. Using USB cable. Start a print and it slowly climbs to around ~193 and stalls, printer times out. So I reset the set point to 193 and it climbs to ~186, stalls and times out. I go t...
- Mon Nov 07, 2016 10:51 pm
- Forum: Feature Requests
- Topic: Diamond 3 colour mixing hot end support
- Replies: 11
- Views: 8630
- Jump to post
Re: Diamond 3 colour mixing hot end support
Count me in on this request. Building a new printer using Azteeg X3Pro board which supports 8 steppers, x,y,z plus 5 extruders. Supports both Marlin and Repetier firmware. Not sure which firmware is winning this race, both are supporting color mixing configurations.
