Search found 3 matches
- Thu Aug 11, 2016 4:03 pm
- Forum: Troubleshooting and Bug Reports
- Topic: No option to auto-configure for dual extrusion?
- Replies: 1
- Views: 1454
- Jump to post
No option to auto-configure for dual extrusion?
Good afternoon, I am trying to get my Axiom Dual running with dual extrusion, but can't get it configured properly. I have a built a profile for the printer, but when I go to "Dual-Extrusion Configuration" wizard, only the profile for my Flashforge Dreamer shows up. In addition, when I go ...
- Thu Jul 07, 2016 2:09 pm
- Forum: Feature Requests
- Topic: [ADDED] Default Feed Rate and Maximum Feed Rate
- Replies: 24
- Views: 74777
- Jump to post
Re: Default Feed Rate and Maximum Feed Rate
One of the main causes of a 3D printer jam is exceeding your 3D printer's feed rate. Most 3D printers cannot print ABS faster than about 13.50mm³/s using a 0.40mm nozzle. Filament manufacturers should tell you this. But instead they give mm/s speed recommendations, which is nearly useless. If your ...
- Sat May 21, 2016 11:07 am
- Forum: General Discussion and Tips
- Topic: Changing speed of support layers
- Replies: 1
- Views: 3482
- Jump to post
Changing speed of support layers
Is there a way to change the speed of only the support layers? I'm printing in PLA with PVA supports and have had some pretty good results, but the prints take forever because I've found PVA works best at very low speeds (10 mm/s). Most of the print I use the PVA support for are fairly large and com...
