Search found 3 matches
- Tue Jun 21, 2016 2:11 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Thin walls suppressed in new version
- Replies: 4
- Views: 2411
- Jump to post
Re: Thin walls suppressed in new version
I'm like 100% sure that 3.0.x also suppressed walls thinner than the extrusion width. Actually I played around with this some weeks ago and only when I set the extrusion width slightly smaller than the wall thickness, it was visible in the sliced model. Then again, it would be probably a good idea t...
- Mon Jun 20, 2016 3:51 pm
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates the same G-Code line multiple times
- Replies: 1
- Views: 1028
- Jump to post
Re: S3D creates the same G-Code line multiple times
Dunno if coincidence or not, but the issue seems to be fixed in 3.1.
- Mon May 23, 2016 1:31 pm
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates the same G-Code line multiple times
- Replies: 1
- Views: 1028
- Jump to post
S3D creates the same G-Code line multiple times
While working on a G-Code converter I noticed that S3D seems to create pointless G-Code or even repeats the very same line of G-Code up to three times. I first stumbled over this in an STL which had some issues but even after I fixed them with Meshmixer, I observed stuff like this: G1 X46.698 Y29.35...
