Search found 2 matches
- Thu Jun 09, 2016 11:22 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Process Bug in 3.1
- Replies: 8
- Views: 6046
- Jump to post
Re: Process Bug in 3.1
Graybeard, I have a setup exactly like yours, and I saw the same error message as you.. however, after upgrade, I cannot connect to my printer any longer (see pic).. I've tried the checkbox for 'accept M101 commands' under g-code, but still the same thing.. I have tried to go back to 3.02, but the s...
- Mon May 30, 2016 6:41 pm
- Forum: Feature Requests
- Topic: ramp cooling by Time + auto setpoint generation
- Replies: 4
- Views: 2226
- Jump to post
Re: ramp cooling by Time + auto setpoint generation
I agree, specific cooling needed other than 'Layers'.. consider the following: I have a bust of a person lying prone, with his hands locked on his chest, printed on his back as is. my cooling needs are along the backs of the arms where I'm getting very bad prints for angles over 60 degrees.. if I ap...
