Simplify3D User Forum

Dobrikk

I'm happy with A and C dimentions, just can see why B should be any different when the only difference with the modell is the inner diameter.

Dobrikk

Rookie on 3D drawing, but trying to make some bushings in 123D, printed out on a Ultimaker 2+ with 0.4 nozzle from Simplify 3D with 0% infill (should be solid printed) tried with 2-3 shells. Bushing A and C print with approximately correct outer diameter (7,96mm) but bushing B comes out about a 0.1 ...

Dobrikk

So there is no other way to not extrude filament while moving then to use Z-lift?

Dobrikk

How do I get rid of the travel lines in the print

SF3 and Ultimaker 2

Z-lift just make a mess.

Morten

Dobrikk

OK

it dosn't come apart on this small part, but on bigger parts, it dosn't get in contact with the perimeter shells and comes loos and thready. looks like shit.

Dobrikk

Anyone know why the first layer on top of support becomes a bridge layer?

It's suppose to be 3 solid layer, but it starts with one bridge layer an then two solid layers.

It happens on all models I try that I use support on.

Dobrikk

Bottom layer overlap, and the last top layer overlap is perfect, infill overlap is at 36% on this print. It's just this second solid area that have this problem.( the solide layer on the picture) You where correct regarding Bridging :-) the bridging accures only on the layer on topp of the support, ...

Dobrikk

Hi Trying to print a model, and have problems with a section of bottom solid not contacting the perimeter shell. The rest of the print is perfect, It happens on the 4 perimeters before the support, and the 4 perimeters after support Top and bottom shell is perfect, it's just this 0,8cm strech that d...

Search found 8 matches

Re: dimension problem

dimension problem

Re: Travel lines over print

Travel lines over print

Re: Not wanted bridge layer

Not wanted bridge layer

Re: No contact with perimeter shell

No contact with perimeter shell