Search found 4 matches
- Sat Jun 18, 2016 7:12 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Firmware configuration error pop-up
- Replies: 2
- Views: 1174
- Jump to post
Re: Firmware configuration error pop-up
That probably means your processes have the firmware override enabled and that's different than the settings you currently have in Tools > Firmware Configuration. They have a video that explains this more: https://www.youtube.com/watch?v=NYPUAqT4UyI Thanks just after i had posted it I was tinkering...
- Sat Jun 11, 2016 8:41 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Adhesion/too low/too high?
- Replies: 2
- Views: 1464
- Jump to post
Re: Adhesion/too low/too high?
I have no clue what's doing this. I'm putting on enough glue. It's a Robo 3D R1Plus. Is it too high to too low? http://imgur.com/a/zgBjZ It looks like your Z-offset is too high. You need to go into processes---> Scripts tab----> Starting Scripts, you need to make your Z offset closer to the bed Exa...
- Sat Jun 11, 2016 8:04 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Firmware configuration error pop-up
- Replies: 2
- Views: 1174
- Jump to post
Firmware configuration error pop-up
Since updating the software I have notice this message every time I boot up to start a new print. Error Pop-Up https://s33.postimg.org/kcrt3jiyn/Error.png This does not stop me from doing anything that is necessary. Just happens each time I open up S3D and start a print. (More Annoying than annythin...
- Sat Jun 11, 2016 7:54 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Simplify3D and Having Calibration Issues with Robo3D R1+
- Replies: 4
- Views: 4562
- Jump to post
Re: Simplify3D and Having Calibration Issues with Robo3D R1+
I also have the R1+ and had a bit of issues at first. At that time I had just bought my printer and then got S3D right away. There was a learning curve at the beginning but now its all good. First off you do NOT need to set the bet temp in your starting script, as long as you have everything defined...
