Search found 4 matches
- Wed Mar 07, 2018 8:11 pm
- Forum: General Discussion and Tips
- Topic: DaVinci repetier connection flow control observations
- Replies: 2
- Views: 2536
- Jump to post
Re: DaVinci repetier connection flow control observations
Thanks. I finally got around to reflashing the software after I did a heating element replacement (went to a E3d v6). Result: exact same thing. Ah well. My AIO is among the first released, perhaps it's something about that.
- Tue Mar 06, 2018 5:00 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Da Vinci 1.0 AiO failed to connect
- Replies: 1
- Views: 1318
- Jump to post
Re: Da Vinci 1.0 AiO failed to connect
I've been struggling with an AIO and v4.0 for years. The only way I made it work was using simplify3d 3.1.1 and setting hardware flow control to on. It does work reliably that way but you lose all the advancements of v 3 to v 4.
- Mon Aug 28, 2017 4:34 pm
- Forum: General Discussion and Tips
- Topic: DaVinci repetier connection flow control observations
- Replies: 2
- Views: 2536
- Jump to post
DaVinci repetier connection flow control observations
I've been using Simplify3d for some time with a DaVinci AIO repetier driven machine and found the 4.0 upgrade has made it impossible to connect. The DaVinci requires hardware serial flow control. Without that it simply goes into a reboot cycle which from other posts indicate can sometimes happen at ...
- Mon Jun 20, 2016 4:34 pm
- Forum: Troubleshooting and Bug Reports
- Topic: DaVinci 1.0A Rebooting When Sending Print with 3.1.0
- Replies: 17
- Views: 9559
- Jump to post
Re: DaVinci 1.0A Rebooting When Sending Print with 3.1.0
Same issue an AiO Symptoms: Printing two copies of a model causes a reboot after upload and no subsequent attempt to print. Removing one copy of the model allows the printer to work normally. Printing more than one copy seems to be the only thing that triggers the behavior for me. Going to try updat...
