Search found 6 matches
- Sat Jul 23, 2016 7:29 am
- Forum: General Discussion and Tips
- Topic: Printed Piece Coming Off Support
- Replies: 2
- Views: 1478
- Jump to post
Re: Printed Piece Coming Off Support
Could you upload the STL so we could find any potential issues?
- Fri Jul 22, 2016 5:36 am
- Forum: General Discussion and Tips
- Topic: What is the 'Emergency stop' button 'Force next' button for?
- Replies: 5
- Views: 3265
- Jump to post
Re: What is the 'Emergency stop' button 'Force next' button
Example: Emergency Stop: My Wanhao i3 print has gone horribly wrong. When I hit Force Stop, it restarts the printer (essentially power cycles it) Force Next: Often times Simplify3D over USB will heat my bed, but fails to heat the extruder (The software fails to detect the temperature of the bed when...
- Tue Jul 05, 2016 12:12 pm
- Forum: Troubleshooting and Bug Reports
- Topic: GCode not working as expected
- Replies: 3
- Views: 2530
- Jump to post
Re: GCode not working as expected
Thanks for the advise everyone. I have set it to one timer with a shorter intetger and will see what happens!
- Tue Jul 05, 2016 6:38 am
- Forum: Troubleshooting and Bug Reports
- Topic: GCode not working as expected
- Replies: 3
- Views: 2530
- Jump to post
GCode not working as expected
Morning all. I noticed recently that once a print had finished the fan would continue running at 100% until either told to print again or I stopped it manuall (On a i3 Duplicator) To fix this I thought I would add a 2 minute wait and then shut the fan off. Unfortunately this does not seem to do anyt...
- Tue Jul 05, 2016 4:02 am
- Forum: General Discussion and Tips
- Topic: Wanhao i3 V2 Z Axis
- Replies: 2
- Views: 1321
- Jump to post
Re: Wanhao i3 V2 Z Axis
Thank you CompoundCarl, I have adjusted it accordingly and its working great! Halved the time and no side effects so far.
- Sun Jul 03, 2016 7:39 am
- Forum: General Discussion and Tips
- Topic: Wanhao i3 V2 Z Axis
- Replies: 2
- Views: 1321
- Jump to post
Wanhao i3 V2 Z Axis
Good morning all. Got my printer 3 days ago and purchased Simplify3d. So far having great fun with success and failure (As expected) One thing I noticed and I am not sure if this is normal. But if my Z axis is at the very top and then home all axis, it takes about 60-80 full seconds for it to reach ...
