You can use something similar to what the Ultimaker 3 already has in it's tool change script. Tool Change Idle Temperatures https://forum.simplify3d.com/viewtopic.php?f=8&t=6684 That's a workaround, too. It's good to have workarounds, but in many cases, the scripts are complicated to handle and pro...
It is doable. I used PLA, on a glass bed. Once the print was done, it would pop the print off the glass, then start over again. All I did was add a few lines of gcode at the end of the file. The file would move the print head to the back of the printer, then move toward the front at a slow speed, t...
You don't need the variable settings wizard, you can just enter the layer where you want to lower the extruder temp on the Temperature tab. They already allow customizing temperatures at specific layers. That's a workaround and doesn't necessarily work: Some layers may take a long time to print, se...
You don't need the variable settings wizard, you can just enter the layer where you want to lower the extruder temp on the Temperature tab. They already allow customizing temperatures at specific layers. That's a workaround and doesn't necessarily work: Some layers may take a long time to print, se...
I also have similar issues. Coasting was on by default, which gave me this kind of seam... (see pictures)
The wall is 2mm, nozzle is 0,8 mm. Later I disabled coasting, the result got much better but not good, not at all (sorry no picture available right now).
Hi! About terms: - "Extrusion multiplier" is clear. It multiplies the amount of extruded plastics compared to calculated need. - Is "Line width" (term of some other slicers than S3D) same "Extrusion width"? - Is "Extrusion width" same than the separation of nozzle path from the previous (in 100% inf...