Simplify3D User Forum

mertseger

Coasing is for those blobs on the end of retraction. I mostly manage that. But printing this blade is imposibble, lower layer is only half of blade and supports doesnt print for only one layer. I have tried like 15 times today and it was all shit. Yes tomorrow I vil cut blade on 2 parts rotate it ve...

mertseger

Abaur blobs, lowest value you can change in S3D is 0,2 mm, i have done this but in one value are blobs and in first lower value there is to little plastic. Is it possible to enter value manualy like 0,9mm instead 0,8 or 1mm?? Blade doenst fit verticaly its 220mm long and I have only 150 verticaly. I...

mertseger

Hi I have model of wind turbine. Today I printed tower. First problem are blobs on start of every layer. Retraction distance is 1 mm. I have change extra restart distance for -0,2 as it is written in print quality troubleshooting guide for Blobs. But then I got other problem it seems there is too li...

mertseger

This is third time in row now hat this happened. Til two days ago everything was OK. But yesterday an 14 minutes this shit..., then again, today one print was ok and now again firmware unresponsive

. Malyan M180

Any idea ?

mertseger

Thanks I will try this, but I level bed as much it is possible on M180. It has only 3 screws and it is hard to get it realy leveled. But this problem only strarts now, I printed few thing before with PLA and didnt have any problems. Will report........

mertseger

Hi I have problem with first layer. This picture show what I should get and what I realy get from printer http://shrani.si/f/1d/mq/1WjfvaEX/slika1.png I read https://www.simplify3d.com/support/print-quality-troubleshooting/#not-extruding-at-start-of-print I tried with different extruder temp 190-210...

mertseger

I have the same problem. Try to print one file from SD card or just cancel print from printer not in S3D.

mertseger

Yes thanks I figure out that he saved that model but where should I delete it, I dont see it anywhere?

mertseger

I had a problem with model and I press emergency stop and disconnect printer (malyan180). Next time I insert new model to S3D and send it to printer (printing over USB). Although in preview mode S3D is showing that I am printing chess figure ( which I want to print), printer is printing a vase that ...

mertseger

Sounds like the extruder fan. That's controlled by the firmware. If you have a second cooling fan, you can control that with the software Thanks both of you, yes I have only extruder fans, so i understand now that those spin all the time. One other question. 1.How do you write script or insert comm...

Search found 13 matches

Re: Blobs and Zits & object orientation

Re: Blobs and Zits & object orientation

Blobs and Zits & object orientation

firmware unresponsive

Re: First layer PLA trouble

First layer PLA trouble

Re: printer keep printing the same object

Re: Printer printing wrong model

Printer printing wrong model

Re: Malyan M180 3D Desktop printer ?