Search found 7 matches

Go to advanced search

by Anthony-MCTM
Mon Aug 06, 2018 10:29 am
Forum: General Discussion and Tips
Topic: How to avoid filling tiny spaces
Replies: 7
Views: 1350

Re: How to avoid filling tiny spaces

My recommended solution.....despite being rejected on the strength of an optional suggestion...….still stands as a plain and simple answer to the reported issue. Dkightley : Your solution is probably the simpliest and the better. But I make this piece for the food industry and they are regularly im...
by Anthony-MCTM
Fri Aug 03, 2018 5:19 am
Forum: General Discussion and Tips
Topic: How to avoid filling tiny spaces
Replies: 7
Views: 1350

Re: How to avoid filling tiny spaces

Hi, thx for the advice but i don't think it can help me :cry:

I had to print waterproof and resistant piece then i only solve it by increase the number of perimeter shells :mrgreen:
by Anthony-MCTM
Fri Aug 03, 2018 2:49 am
Forum: General Discussion and Tips
Topic: How to avoid filling tiny spaces
Replies: 7
Views: 1350

How to avoid filling tiny spaces

Hello, printer community, This topic probably already exists but I couldn't find it, all my apologies :oops: In fact I regularly have small trajectory problems in my gCode that complicates printing for nothing. And I guess there has to be a parameter to set to avoid that. On the first image, you can...
by Anthony-MCTM
Thu Oct 20, 2016 6:18 am
Forum: Troubleshooting and Bug Reports
Topic: Wrong slice in cylinder
Replies: 10
Views: 3949

Re: Wrong slice in cylinder

OK, thanks guys, it was a too hight resolution it cause this issue ! :D
by Anthony-MCTM
Wed Oct 19, 2016 12:40 pm
Forum: Troubleshooting and Bug Reports
Topic: Wrong slice in cylinder
Replies: 10
Views: 3949

Re: Wrong slice in cylinder

Ok, thanks guys.

The model was export with the best definition of my 3Dsoftware (spaceclaim).

The STL file weighs 200Mo.

How can i have an highter résolution ?
by Anthony-MCTM
Wed Oct 19, 2016 7:53 am
Forum: Troubleshooting and Bug Reports
Topic: Wrong slice in cylinder
Replies: 10
Views: 3949

Wrong slice in cylinder

Hello S3D's community, I'm not English, I hope you will easily understand me. I have a problem when I slice a cylindrical part. Although my STL file is in a very high definition, when simplify 3D slices my part it "braids" / "plaits" the cylinder. Look at the photo 2016-10-18 10_14_33-Cortana.png P1...
by Anthony-MCTM
Wed Oct 19, 2016 7:35 am
Forum: Troubleshooting and Bug Reports
Topic: Gap to extrude support
Replies: 1
Views: 812

Gap to extrude support

Hello Simplify3D's community, I'm not English I hope you will easily understand me. I am preparing a Gcode to print a part with PVA support. My problem is about visualisation in S3D. If I keep the original setting for my printer (Raise N2+), the visualisation of printing is wrong. There is a gap bet...

Go to advanced search