Search found 3 matches
- Mon Nov 21, 2016 3:48 am
- Forum: General Discussion and Tips
- Topic: Infill density variation along X-axis
- Replies: 5
- Views: 3345
- Jump to post
Re: Infill density variation along X-axis
Hi There I have also tested this now to see if it works. So my problem is that I have a square but with a block on top of it. If I just changed the profile at a certain line height, whilst the print looked OK, it seemed to create a weak point where I went for 20 to 100% infil. It was as if the part ...
- Thu Nov 10, 2016 5:17 am
- Forum: General Discussion and Tips
- Topic: Infill density variation along X-axis
- Replies: 5
- Views: 3345
- Jump to post
Re: Infill density variation along X-axis
OK, so that seems like an obvious way forward that i should maybe have known about. So just as if you were using dual extruders etc, i can just split the obect and apply a different FFF to each part.
TY for your help.
TY for your help.
- Wed Nov 09, 2016 10:29 am
- Forum: General Discussion and Tips
- Topic: Infill density variation along X-axis
- Replies: 5
- Views: 3345
- Jump to post
Infill density variation along X-axis
Hi There One thing I really like about Simplify3D is the variation of processes you can use between layers. Its going to revolutionize my printing! However I have a model that has 2 screw points at the back which I would like to print 100% density, the rest of the model can be 20% infill density as ...
