Simplify3D User Forum

ganner918

I printed an old cubepro file I'd made with Simplify3D and this one printed fine. So now I'm getting confused. The older file was from an older version of S3D, before they added the built in support for the CubePro. Thinking back, too, I think after thatS3D upgrade was when I first started having so...

ganner918

Thanks, I'll try printing an old file. I just know that yesterday I printed the same piece from Simplify3D and from the CubePro software, and I got a good part from the CubePro file, and a complete trash part from the Simplify3D file.

ganner918

Without considering the consequences (and without having read this thread), I updated my CubePro's firmware to v2.00 so that I could run a print from the CubePro software - I'd thought with simple prints that didn't need any tweaking of support material or print settings I could just use the quicker...

ganner918

I realize I'm bumping a rather old thread, but I just ran into this problem and found this in search. I have multiple parts on a single process, auto generate support, and then manually remove supports as needed. I have one part where I manually remove all support, and when I "prepare to print,...

Search found 4 matches

Re: Tip of the Day 30 - Using 3DTouch, CubeX,CubePro and Rap

Re: Tip of the Day 30 - Using 3DTouch, CubeX,CubePro and Rap

Re: Tip of the Day 30 - Using 3DTouch, CubeX,CubePro and Rap

Re: Removed Supports still being generated and printed