Search found 5 matches
- Mon Jul 22, 2019 3:43 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Strange print pattern and gaps in first and last layers
- Replies: 5
- Views: 2437
- Jump to post
Re: Strange print pattern and gaps in first and last layers
Unfortunately, not.
- Fri Jul 19, 2019 7:04 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Strange print pattern and gaps in first and last layers
- Replies: 5
- Views: 2437
- Jump to post
Strange print pattern and gaps in first and last layers
I upgraded to version 4.1.2 and my prints have gone from great to unacceptable. As you can see in the attached image, there are gaps in the first layer and this very strange print pattern that takes way too long to print. It prints a couple of those leaf-shaped patterns in the center of the print an...
- Wed Jun 20, 2018 2:06 pm
- Forum: General Discussion and Tips
- Topic: Upgrade to 4.0.1 left 4.0.0 behind
- Replies: 2
- Views: 1422
- Jump to post
Upgrade to 4.0.1 left 4.0.0 behind
Is it safe to delete the 4.0.0 folder under Program Files after installing 4.0.1? Looks to have all the same files as the new installation. I deleted the 4.0.0 folder and the newer release seems to work OK.
- Thu May 04, 2017 3:01 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Seam/Z-scarring significantly better in Silc3r - Settings?
- Replies: 14
- Views: 14438
- Jump to post
Re: Seam/Z-scarring significantly better in Silc3r - Setting
I am having the same problem. A line of sharp-edged blobs up the O.D. of a cylinder. The straight cylinder has a thick part at the bottom of 3/8" wall thickness and the O.D. in that portion is OK. But as soon as it transitions to a 1/9" wall thickness, the blobs appear and extend up the 2&...
- Sat Nov 26, 2016 2:10 pm
- Forum: General Discussion and Tips
- Topic: Filament school (for me)
- Replies: 1
- Views: 1242
- Jump to post
Filament school (for me)
Couple of new to me thoughts/actions: 1. When I switch from a high temperature filament to, say, PLA, I now swap out the nozzle and PTFE tube I used with the high temperature filament because if I get the nozzle hot enough to melt the high temp filament so I can push it out of the nozzle with the PL...
